Fixed shears

- Mar 14, 2018-

Fixed shears

     The plane shears of the fixed shearing unit and the ranch and the social team installed in the shearing room. The wool felt shearing unit is installed in a fixed building. It can cover the weather and the sun. The room should be dry, well-lit and well-ventilated. The walls should be white and sterilized. The total area of the premises must not be less than 350 m2. The required width is 7-11 meters, 50-80 meters long and 8 meters high.

     Generator equipment. In a shearing room without a grid power supply, a power generation device can be set, and the power of the power generation device can be selected as needed. For safety and reduction of engine noise, the power generation equipment is separately installed in the under-shelf or in a special small room, more than 15 meters away from the shearing machine room. The unit should be screwed on the sleeper to be horizontal. The distance from the generator set to the shearing room is not less than 3 meters from the ground.

     The power generation equipment has a grounding tube with a hollow length of 2 meters and a diameter of 50.8 millimeters. The upper part has an ear-shaped water filling hole 1 and a terminal 2 and the other end is a pointed cone.

     The first grounding tube is buried on the same side of the generator's electricity meter, with the opposite line at the terminal 2 (with a cross-sectional area of not less than 4 mm) and the generator neutral line, and the generator device housing is connected. The second grounding tube is buried in the end of the grid and is connected to the motor body.

     The shearing work is performed on the shearing table in the room. The shearing table is installed in two rows. If each shearing worker has a shearing station, each row should have six dimensions (length, width, height) of 1.5 x 1.2 x 0.5 meters. If the equipment at the hair removal station does not have to be moved at all, a full board (size 1.2 x 0.5 m) can be installed in each row as a shearing station.

     A wood strip with a section of 50 x 120 mm was placed directly above the centerline of the shearing station. The electricity grid from the power generation equipment to the premises is fixed on this wood strip. A switch (one for each cutting head) is provided on the electric network and leads to the motor terminal block of the shearing machine. The grid should be fixed to a height that facilitates the use of switches (1.5 m).

     The motor was hung from the wooden board with a hook. The board was mounted 0.2-0.3 meters above the edge of the shearing table. The distance between the motors is 1.8 meters and the distance from the floor at the end of the motor shaft is 1.8 meters. The motor switch should be 0.3-0.4 meters to the left of the motor for ease of operation.